microcontrollers:todo
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
microcontrollers:todo [2012/01/15 15:50] – [Done] mithat | microcontrollers:todo [2012/01/26 12:21] (current) – mithat | ||
---|---|---|---|
Line 2: | Line 2: | ||
===== TODO ===== | ===== TODO ===== | ||
- | * PIC SDCC | + | * PC + JALv2 |
- | * install | + | * install |
- | * IDE or other dev. env. | + | |
- | * successful compile | + | |
- | * simulate | + | |
- | * JALv2 | + | |
- | * install bins and libs and | + | |
* IDE or other dev. env. | * IDE or other dev. env. | ||
* successful compile | * successful compile | ||
- | * simulate | + | * simulate |
* AVR | * AVR | ||
- | * setup and run an AVR siluavr session | ||
* setup freeware AVR simulation in WINE | * setup freeware AVR simulation in WINE | ||
+ | * **Pick a setup and start coding [[microcontrollers: | ||
===== Done ===== | ===== Done ===== | ||
* AVR | * AVR | ||
- | * get a handle on AVR IDE/dev. env. and set at least one up (used CodeBlocks, Eclipse, Geany, and Qt Creator; CodeBlocks and Eclipse preferred). | + | |
- | * write AVR code and successfully | + | |
+ | * successful | ||
+ | * setup and run an AVR simulavr session ([[http:// | ||
+ | ===== Scrubbed ===== | ||
+ | * PIC + SDCC | ||
+ | * install tools (incl. gpsim) | ||
+ | * sdcc: precompiled linux binary from [[http:// | ||
+ | * IDE or other dev. env. | ||
+ | * successful compile (see [[http:// | ||
+ | * simulate | ||
microcontrollers/todo.1326642653.txt.gz · Last modified: 2012/01/15 15:50 by mithat