kicad:using_arbitrary_spice_engines_in_kicad_5
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
kicad:using_arbitrary_spice_engines_in_kicad_5 [2018/10/17 15:29] – mithat | kicad:using_arbitrary_spice_engines_in_kicad_5 [2019/01/04 21:41] (current) – mithat | ||
---|---|---|---|
Line 21: | Line 21: | ||
# * Set SPICE_ENGINE to your desired SPICE engine. (Hack the line | # * Set SPICE_ENGINE to your desired SPICE engine. (Hack the line | ||
# where it's invoked to add any needed command line parameters.) | # where it's invoked to add any needed command line parameters.) | ||
- | # * In the KiCad Netlist dialog Spice tab, set the simulator to this file | + | # * In the KiCad Netlist dialog' |
- | # using an absolute path. | + | # file using an absolute path. |
- | # * In the KiCad Netlist dialog Spice tab, Run Simulator. | + | # * In the KiCad Netlist dialog' |
# ----- config --------------------------------------------------------- | # ----- config --------------------------------------------------------- | ||
Line 30: | Line 30: | ||
# The command for the SPICE engine you want to use: | # The command for the SPICE engine you want to use: | ||
- | SPICE_ENGINE=spiceopus | + | SPICE_ENGINE="xterm -e ngspice" |
# ---------------------------------------------------------------------- | # ---------------------------------------------------------------------- | ||
kicad/using_arbitrary_spice_engines_in_kicad_5.txt · Last modified: 2019/01/04 21:41 by mithat