Differences

This shows you the differences between two versions of the page.

--- arduino:stm32_blue_pill [2019/07/17 04:08] – [Project config] mithat
+++ arduino:stm32_blue_pill [2019/09/15 00:47] – [Resources] mithat
@@ Line 41: / Line 41: @@
 ===== Programming =====
-  * Move the top jumper (i.e., the one furthest from the Reset button) to the 1 position (i.e., closest to the microcontroller).
+  * Move the top jumper (i.e., the one furthest from the Reset button) to the 1 position (i.e., closest to the microcontroller IC).
   * Push reset.
   * Upload the sketch.
@@ Line 48: / Line 48: @@
 To put the device into "use" mode, move the top jumper back to 0 (left) position.
- ===== Resources =====
+===== Pinout =====
+{{:arduino:bluepillpinout.gif|}}
+from [[https://wiki.stm32duino.com/images/a/ae/Bluepillpinout.gif | here]]
+===== Resources =====
+Note that the stm32duino.com domain has gone down at least once because it exceeded the host's traffic limit.
   * [[https://wiki.stm32duino.com/index.php?title=Blue_Pill|STM32duino wiki page]]
   * [[https://www.stm32duino.com/|Forum]]
   * Pinout: [[https://wiki.stm32duino.com/images/a/ae/Bluepillpinout.gif | here]] and [[https://www.stm32duino.com/viewtopic.php?t=2202| here ]]