arduino:stm32_blue_pill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
arduino:stm32_blue_pill [2019/01/03 04:26] – [Hardware] mithat | arduino:stm32_blue_pill [2019/09/15 00:47] – [Resources] mithat | ||
---|---|---|---|
Line 33: | Line 33: | ||
* //Board// : " | * //Board// : " | ||
- | * //Variant// : " | + | * //Variant// : " |
* //Upload method// : " | * //Upload method// : " | ||
+ | * //CPU Speed(MHz)// | ||
* // | * // | ||
* //Port// : wherever the serial converter is plugged into | * //Port// : wherever the serial converter is plugged into | ||
Line 40: | Line 41: | ||
===== Programming ===== | ===== Programming ===== | ||
- | * Move the top jumper (i.e., the one furthest from the Reset button) to the 1 position (i.e., closest to the microcontroller). | + | * Move the top jumper (i.e., the one furthest from the Reset button) to the 1 position (i.e., closest to the microcontroller |
* Push reset. | * Push reset. | ||
* Upload the sketch. | * Upload the sketch. | ||
Line 47: | Line 48: | ||
To put the device into " | To put the device into " | ||
- | ===== Resources ===== | + | ===== Pinout ===== |
+ | {{: | ||
+ | from [[https:// | ||
+ | |||
+ | ===== Resources ===== | ||
+ | Note that the stm32duino.com domain has gone down at least once because it exceeded the host's traffic limit. | ||
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
* Pinout: [[https:// | * Pinout: [[https:// |
arduino/stm32_blue_pill.txt · Last modified: 2022/06/26 01:18 by mithat