arduino:stm32_blue_pill
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
arduino:stm32_blue_pill [2020/02/27 18:00] – mithat | arduino:stm32_blue_pill [2020/09/20 20:42] – [STM32 "Blue Pill"] mithat | ||
---|---|---|---|
Line 2: | Line 2: | ||
Some quick notes about setting up a STM32F103C8T6 [[https:// | Some quick notes about setting up a STM32F103C8T6 [[https:// | ||
+ | |||
+ | <WRAP center round info 60%> | ||
+ | This describes the process for settings things up using the now **unsupported** and obsolete [[https:// | ||
+ | |||
+ | An alternative that is currently supported is the [[https:// | ||
+ | </ | ||
===== Setup ===== | ===== Setup ===== | ||
Line 10: | Line 16: | ||
<WRAP center round important 90%> | <WRAP center round important 90%> | ||
- | Be careful! Some serial converter boards put out 5V as VCC even when set to 3.3V mode. Applying 5V to the 3.3V main supply line of a Blue Pill will kill it. | + | **Be careful!** |
+ | |||
+ | Some serial converter boards put out 5V as VCC even when set to 3.3V mode. Applying 5V to the 3.3V main supply line of a Blue Pill will kill it. | ||
Lots of pins on the STM32F103C8T6 are purported to be 5V tolerant, but the main DC isn't. I don't know if TX/RX are. | Lots of pins on the STM32F103C8T6 are purported to be 5V tolerant, but the main DC isn't. I don't know if TX/RX are. | ||
Line 56: | Line 64: | ||
==== STM32duino ==== | ==== STM32duino ==== | ||
- | Note that the stm32duino.com domain | + | The [[https:// |
* [[http:// | * [[http:// | ||
Line 62: | Line 70: | ||
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
- | * [[https:// | + | |
+ | | ||
+ | |||
==== Other ==== | ==== Other ==== |
arduino/stm32_blue_pill.txt · Last modified: 2022/06/26 01:18 by mithat