arduino:configuring_netbeans_for_arduino_development
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
arduino:configuring_netbeans_for_arduino_development [2018/08/24 16:05] – mithat | arduino:configuring_netbeans_for_arduino_development [2018/08/24 16:20] – [Arduino-Build] mithat | ||
---|---|---|---|
Line 4: | Line 4: | ||
===== The tool collection ===== | ===== The tool collection ===== | ||
- | + | NetBeans will be happiest if you let it know where the build tools for your project live. Set up a new tool collection for Arduino along the lines of the figure below: | |
- | I use either [[https:// | + | |
{{: | {{: | ||
+ | If you are using an Arduino that uses something other than an AVR microcontroller, | ||
===== The Makefile and config ===== | ===== The Makefile and config ===== | ||
+ | |||
+ | I use either [[https:// | ||
==== Arduino-Makefile ==== | ==== Arduino-Makefile ==== | ||
- | When creating a new project with Arduino-Makefile, | + | When creating a new project with Arduino-Makefile, |
<file make Makefile> | <file make Makefile> | ||
Line 35: | Line 37: | ||
==== Arduino-Build ==== | ==== Arduino-Build ==== | ||
+ | |||
If you're using Arduino-Build, | If you're using Arduino-Build, | ||
Line 61: | Line 64: | ||
You will also need an '' | You will also need an '' | ||
- | < | + | < |
# === Arduino path === | # === Arduino path === | ||
ARDUINO_PATH=/ | ARDUINO_PATH=/ | ||
Line 80: | Line 83: | ||
===== Code completion ===== | ===== Code completion ===== | ||
- | While your setup should be working now, NB will be shouting at you a lot about things not being defined, etc. That's because you need to add [[arduino: | + | While your setup should be working now, NetBeans |
arduino/configuring_netbeans_for_arduino_development.txt · Last modified: 2024/02/05 19:06 by mithat