Differences

This shows you the differences between two versions of the page.

--- arduino:burning_a_bootloader [2017/03/08 19:12] – created mithat
+++ arduino:burning_a_bootloader [2017/03/08 19:15] (current) – [Using an Arduino Uno as the ISP] mithat
@@ Line 4: / Line 4: @@
 TL;DR:
-  - Load the ArduinoISP sketch from //Files > Examples// into the Arduino that will function as the programmer.
-  - Wire up the Atmega that needs a bootloader burned onto it to the programmer Arduino.
   - Select the correct port in //Tools > Port//
-  - Select the correct "host" uC type in //Tools > Board// (e.g. Arduino/Genuino Uno for ATMEGA328P-PU)
+  - Load the ArduinoISP sketch from //Files > Examples// into the Arduino that will function as the programmer.
-  - Select "Arduino is ISP" under //Tools > Programmer//
+  - Select "Arduino as ISP" under //Tools > Programmer//
+  - Select the correct target microcontrller type in //Tools > Board// (e.g. Arduino/Genuino Uno for ATMEGA328P-PU)
+  - Wire up the target microcontrller to the Arduino that's functioning as the programmer.
   - Select //Tools > Burn Bootloader//