arduino:burning_a_bootloader
Differences
This shows you the differences between two versions of the page.
arduino:burning_a_bootloader [2017/03/08 19:12] – created mithat | arduino:burning_a_bootloader [2017/03/08 19:15] (current) – [Using an Arduino Uno as the ISP] mithat | ||
---|---|---|---|
Line 4: | Line 4: | ||
TL;DR: | TL;DR: | ||
- | - Load the ArduinoISP sketch from //Files > Examples// into the Arduino that will function as the programmer. | ||
- | - Wire up the Atmega that needs a bootloader burned onto it to the programmer Arduino. | ||
- Select the correct port in //Tools > Port// | - Select the correct port in //Tools > Port// | ||
- | - Select | + | - Load the ArduinoISP sketch from //Files > Examples// into the Arduino that will function as the programmer. |
- | - Select "Arduino | + | - Select |
+ | - Select the correct target microcontrller | ||
+ | - Wire up the target microcontrller to the Arduino | ||
- Select //Tools > Burn Bootloader// | - Select //Tools > Burn Bootloader// | ||
arduino/burning_a_bootloader.txt · Last modified: 2017/03/08 19:15 by mithat