arduino:basic_interaction
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| arduino:basic_interaction [2012/09/13 05:47] – [Switch controlled LED] mithat | arduino:basic_interaction [2012/09/13 05:47] – mithat | ||
|---|---|---|---|
| Line 9: | Line 9: | ||
| Of the two, polling is probably easier to get started with. Following is a simple example of using polling. | Of the two, polling is probably easier to get started with. Following is a simple example of using polling. | ||
| - | ===== Switch controlled LED ===== | + | ===== Switch-controlled LED ===== |
| This example uses polling to determine the state of a switch. If the switch is pressed, Arduino will turn an LED on. If it is not pressed, it will turn the LED off. | This example uses polling to determine the state of a switch. If the switch is pressed, Arduino will turn an LED on. If it is not pressed, it will turn the LED off. | ||
arduino/basic_interaction.txt · Last modified: 2012/09/14 01:19 by mithat