arduino:arduino_without_a_bootloader
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| arduino:arduino_without_a_bootloader [2020/01/04 02:27] – [Hardware] mithat | arduino:arduino_without_a_bootloader [2020/01/04 02:28] – [Procedures] mithat | ||
|---|---|---|---|
| Line 39: | Line 39: | ||
| </ | </ | ||
| ===== Procedures ===== | ===== Procedures ===== | ||
| - | As is the case when uploading a program to your Arduino using a bootloader, when uploading a program using a programmer you must specify what the target board is. So when doing any of the following, make sure //Tools > Board// and //Tools > Processor// are set correctly for your board. | + | As is the case when uploading a program to your Arduino using a bootloader, when uploading a program using a programmer you must specify what the target board is. So when doing any of the following, make sure //Tools > Board// and //Tools > Processor// |
| Now is also a good time to mention a significant caveat about using a programmer as described here. <WRAP center round important 80%> | Now is also a good time to mention a significant caveat about using a programmer as described here. <WRAP center round important 80%> | ||
arduino/arduino_without_a_bootloader.txt · Last modified: 2022/05/30 05:46 by mithat