arduino:arduino_without_a_bootloader
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
arduino:arduino_without_a_bootloader [2020/01/04 02:25] – [Hardware] mithat | arduino:arduino_without_a_bootloader [2020/01/04 02:29] – [Case 1: Uno or Nano with USBtinyISP] mithat | ||
---|---|---|---|
Line 29: | Line 29: | ||
Below, I cover a few cases to get you started. Most of these use the USBtinyISP.((As near as I can tell, the original source of the USBtinyISP design is Dick Streefland' | Below, I cover a few cases to get you started. Most of these use the USBtinyISP.((As near as I can tell, the original source of the USBtinyISP design is Dick Streefland' | ||
- | The original USBtinyISP has a built-in 3x2 keyed IDC cable that carries the signals | + | The original USBtinyISP has a built-in 3x2 IDC cable that carries the signals |
- | If you are using a USBtinyISP clone, there' | + | If you are using a USBtinyISP clone, there' |
Depending on the board you are programming, | Depending on the board you are programming, | ||
Line 39: | Line 39: | ||
</ | </ | ||
===== Procedures ===== | ===== Procedures ===== | ||
- | As is the case when uploading a program to your Arduino using a bootloader, when uploading a program using a programmer you must specify what the target board is. So when doing any of the following, make sure //Tools > Board// and //Tools > Processor// are set correctly for your board. | + | As is the case when uploading a program to your Arduino using a bootloader, when uploading a program using a programmer you must specify what the target board is. So when doing any of the following, make sure //Tools > Board// and //Tools > Processor// |
Now is also a good time to mention a significant caveat about using a programmer as described here. <WRAP center round important 80%> | Now is also a good time to mention a significant caveat about using a programmer as described here. <WRAP center round important 80%> | ||
Line 57: | Line 57: | ||
</ | </ | ||
- | Directly uploading a sketch to an Uno or Nano using a USBtinyISP is very straightforward: | + | Directly uploading a sketch to an Uno or Nano using a USBtinyISP is pretty |
- Configure your IDE to use the USBtinyISP: //Tools > Programmer " | - Configure your IDE to use the USBtinyISP: //Tools > Programmer " |
arduino/arduino_without_a_bootloader.txt · Last modified: 2022/05/30 05:46 by mithat